SimplTrack3 - Firmware Changelog

Firmware Version:1.0.89

Release Date: April 21, 2026

Change Log

Tracking Start/Stop Location Options Added configurable start and stop position options for tracking, allowing users to define the camera’s position when tracking is enabled or disabled within Automation > Settings. Users can select from Presets 0–9, Home, or choose to keep the camera in its current position (“Stay in Place”), providing greater control over camera behavior during tracking transitions.
Target Lost Action - Options Added new configuration options for where the camera moves when a tracked subject is lost within Automation > Settings. Available options include Presets 0–9, Home, or Stay in Place.
Image Orientation and Inverted Tracking Control in Web UI Added an Image Orientation control under Image > Advanced in the Web UI Dashboard. Previously, this setting was only available through the OSD menu. The available options are Flip, Mirror, and Flip & Mirror. Flip & Mirror settings allow the camera to be installed in an inverted position and support inverted tracking operation.

Zoom While Tracking: Enabled - Composition Behavior When Zoom While Tracking is enabled, the camera’s zoom level and subject framing are determined by the Zoom Limit setting (values 0–7): 0–2: Close-up view 3–5: Half-body view 6–7: Whole-body view Value 4 is recommended for typical use cases.
Zoom While Tracking: Disabled – Preset Behavior When Zoom While Tracking is disabled, the camera uses Preset 1 (Subject Preset) to determine the zoom level during tracking.
Tilt While Tracking Disabled - Zoom Behavior When Tilt while Tracking is set to Off, zoom adjustments are disabled during tracking. The camera maintains the zoom level defined by preset 1.

Inverted Mount: Tracking/Framing Resolved an issue that prevented Auto Tracking and Framing from operating when the SimplTrack 3 was mounted in an inverted position.
White Balance: VAR Settings reset after a Reboot Fixed an issue where VAR settings would reset after a Reboot.

Hive Studio 404 Error Resolved an issue where the Hive Studio page returned a 404 error on first access.
Digital Zoom Field Display (Web UI) Corrected a display issue where the Digital Zoom field did not populate with the default “Off” setting.
NDI® Settings Validation Message Improved the field requirement error message on the NDI Settings page for clearer configuration guidance.

Network Reset - NTP Settings NTP settings do not revert to default values after performing a Network Reset.
VISCA Power Command/Standby Limitation After placing the camera into Standby using the VISCA Power Off command or the IR remote, it cannot be powered back on via either VISCA or the IR remote. A power cycle is required.
H265 Encoding Display Mismatch When any stream (PTZ Stream, Reference Stream, or Stream 3) is set to H.265, all streams output H.265. However, the Web UI does not update the Encoding Profile field for the Reference Stream or Stream 3 accordingly.
Reboot - Password Creation Prompt In rare cases, after rebooting via the Web UI, the new Password Creation prompt appears unexpectedly and generates an error if a new password is entered. Workaround: Refresh the page to clear the prompt and log in normally.